Table of Contents
Advertisement
Controls and input connections
A wide variety of external equipment can be connected to the input sockets on the side of the television.
While all the necessary adjustments and controls for the television are made using the remote control, the
buttons on the television may be used for some functions.
USB 1/USB 2 port
Media Player
USB HDD connection port (USB 2)
COMMON INTERFACE
The Common Interface is for a
Conditional Access Module (CAM).
Contact a service provider.
NOTE:
• Software update of a CI Plus CAM may
occur automatically if instigated by the
broadcaster. This could cause the
cancellation of any Reminders/Recordings
during this process.
• Some CI or CI+ CAM may not be supported.
Switching on
If the RED LED is not lit, check that the mains plug is
connected to the power supply and press
control; it may take a few moments. The GREEN LED will be lit.
To put the television into Standby, press
control. To view the television, press
take a few seconds to appear.
For energy saving:
We recommend that you use the television with the factory
settings. The factory settings are for energy saving.
Unplugging the mains plug will cut energy use to zero for
all televisions. This is recommended when the television is
not being used for a long time, e.g. when on holiday.
Reducing the brightness of the screen will reduce energy use.
Energy efficiency cuts energy consumption and thus saves
money by reducing electricity bills.
NOTE: Putting the television into standby mode will reduce
energy consumption, but will still draw some power.
Using the menu system
Press MENU on the remote control to display the menu.
The five initial topics icons will appear. As each symbol is
C
c
selected by pressing
or
Bb C c
Press
to enter a sub menu and then enter a further
sub menu to see any options.
NOTE: The same menu is displayed in DTV (Digital TV) and
ATV (Analogue TV) modes; however, where some items are
not available in a mode, they will appear grayed out.
ORANGE LED – Programme timer set (digital only)
RED LED – Programme timer Active (digital only)
1
on the remote
1
on the remote
1
again. The picture may
on the remote control.
Ambient
Light Sensor
Camera Sensor
To use the option, press
move up and down and press
setting. Follow the on-screen instructions. The functions of
each menu are described in detail throughout the manual.
Using the TV controls and connections
• To turn on or off the TV, press
• To alter the volume, press
• To alter the programme position, press
• Press MENU and
picture options.
Press MENU to finish.
• To select an external input, press
input source is selected.
The Media Player feature provides access to photo, movie and
music files stored on a USB storage device that is connected
via the USB 1 or USB 2 port or on a network device.
The USB 2 port has to be used with a USB HDD (not supplied)
in order to record/playback TV programmes.
NOTE: The USB socket has limited functionality and Toshiba
can take no responsibility for damage to other connected
equipment.
Please always refer to the owner's manual of the equipment to be
connected for full details.
NOTE: Interactive video games that involve shooting a "gun"
at an on-screen target may not work with this TV.
15
CONNECTING YOUR TV
FOR SERVICE
USE ONLY
Control panel
RED LED – Standby
GREEN LED – Power on
B
b
and
on the remote control to
C
c
or
to select your desired
!
.
2
+ –.
p Bb
p Bb
2
,
+ – to control the sound and
o
until the appropriate
.
Advertisement
Table of Contents
