Rinse Aid; Setting Amount Of Rinse-Aid; Switching Off Rinse-Aid Refill Indicator - Siemens Dishwasher Instructions For Use Manual

en

Rinse aid

As soon as the rinse-aid refill indicator
lights up on the control panel
refill with rinse aid.
The rinse aid is required for stain-free
utensils and clear glasses.
Use only rinse aid for domestic
dishwashers.
Combined detergents with rinse-aid
component may be used up to a water
hardness of 21_ dH (37_ fH, 26_ Clarke,
3,7 mmol/l) only. If the water hardness
is over 21_ dH, rinse-aid must be used.
Open the dispenser
the plate on the cover.
Carefully pour in the rinse aid to just
below the edge of the filler opening.
Close cover until it clicks shut.
To prevent excessive foam formation
during the next rinse cycle, remove
any rinse aid which has run over with
a cloth.
8
,
5
by lifting
29

Setting amount of rinse-aid

The amount of rinse-aid dispensed can be
set from to
is .
Do not change the amount of rinse-aid
unless streaks (select lower setting) or
water stains (select higher setting) are left
on the utensils.
Open the door.
Switch on ON/OFF switch
Hold down programme button A
and press START button
the digital display is indicated
Release both buttons.
The LED for button A flashes and
the digital display displays the factory
setting .
Press programme button A until the
factory set value
the digital display
To change the setting,
press programme button C .
Each time the button is pressed, the set
value increases by one level; when the
value of has been reached, the
display jumps back to
Press START button
The set value is saved.
Close the door.
Switching off rinse-aid refill
indicator
If the rinse-aid refill indicator
impaired (e.g. when using combined
detergents containing rinse-aid
component), it can be switched off.
Proceed as described under "Setting
amount of rinse-aid" and set the value
to .
The rinse-aid refill indicator
switched off.
. The factory setting
.
1
until on
8
.
is indicated on
.
9
(off).
.
8
is
5
is now
5