Waste-Water Connection; Fresh-Water Connection; Electrical Connection; Removing The Appliance - Siemens Dishwasher Instructions For Use Manual

en
The appliance can easily be installed
in a fitted kitchen between wooden and
plastic walls. If the plug is not freely
accessible following installation,
an allpole disconnector with a contact
opening of at least 3 mm must be fitted
on the installation side to satisfy the
relevant safety regulations.

Waste-water connection

The required work sequence can be
found in the installation instructions.
If required, fit a siphon with an drainage
connection.
Connect the waste-water hose to the
drainage connection of the siphon with
the enclosed parts.
Ensure that the drainage hose is not
kinked, crushed or twisted and that
there is no cover plate in the drainage
to prevent the waste water from flowing
out!

Fresh-water connection

Connect the fresh-water connection
to the tap according to the installation
instructions with the enclosed parts.
Ensure that the fresh-water connection
is not kinked, crushed or twisted.
When replacing the appliance,
always use a new water supply hose.
Water pressure:
at least 0.05 MPa (0.5 bar), maximum
1 MPa (10 bar). At a higher water
pressure: connect pressure-reducing
valve ahead.
Inlet rate:
minimum 10 litres/minute
Water temperature:
cold water preferred; hot water max.
temp. 60 °C.
24

Electrical connection

Connect the appliance to an alternating
current only, ranging from 220 V to
240 V and 50 Hz or 60 Hz via a correctly
installed socket with protective earth
conductor. See rating plate for required
fusing .
32
The socket must be near the appliance
and freely accessible following
installation.
The connection may be modified
by technicians only.
A power cord extension may be
purchased from customer service only.
Use only a residual-current-operated
circuit-breaker which features the
symbol. Only this extension guarantees
compliance with the currently valid
regulations.

Removing the appliance

Also observe the sequence of worksteps
here.
Disconnect the appliance from
the power supply.
Turn off the water supply.
Disconnect the waste water and fresh
water connections.
Loosen the fastening screws under
the worktop.
If fitted, remove the base panel.
Pull out the appliance, carefully pulling
the hose behind.