Switching Off The Appliance; Interrupting The Programme; Terminating The Programme (Reset); Changing The Programme - Siemens Dishwasher Instructions For Use Manual

To change the setting,
press programme button C .
Each time the button is pressed, the set
value increases by one level; when the
value of has been reached, the
display jumps back to
Press START button
is saved.
Close the door.

Switching off the appliance

Short time after the end of the programme:
Open the door.
Switch off ON/OFF switch
Turn off the tap (not applicable
if Aqua-Stop fitted).
Remove the utensils when they have
cooled down.
Warning
At the end of the programme please open
the door fully and not partially when
emptying the dishwasher. Any escaping
water vapour could damage sensitive
worktops.

Interrupting the programme

Open the door.
Switch off ON/OFF switch
The LEDs go out. The programme
is saved.
If the door was opened on an appliance
which has a warm water connection
or is heated, first leave the door ajar
for several minutes and then close.
Otherwise, expansion (pressure) may
cause the appliance door to spring
open or water to run out of the
appliance.
To continue the programme, switch
on the ON/OFF switch
Close the door.
(off).
, the set value
8
.
1
.
1
again.
1
Terminating the programme
(Reset)
Open the door.
Press START button
approx 3 sec.
on the digital display
Close the door.
The programme sequence lasts
approx. 1 min.
is indicated on the digital
display (buzzer sounds).
9
Open the door.
Switch off ON/OFF switch
Close the door.

Changing the programme

When the START button
pressed, the programme cannot be
changed.
The only way a programme can be
changed is by Cancel programme (reset).

Intensive drying

The final rinse uses a higher temperature
which improves the drying result.
The running time may increase slightly.
(Caution if utensils are delicate!)
Open the door.
Switch on ON/OFF switch
Hold down programme button A
and press START button
the digital display
Release both buttons.
The LED for button A flashes and
the digital display displays the factory
setting .
Press programme button A until the
factory set value
the digital display
To change the setting,
Press the button C to switch
intensive drying on
Press START button
The set value is saved.
Close the door.
en
for
8
is indicated
.
9
.
1
has been
8
.
1
until on
8
is indicated.
is indicated on
.
9
or off .
.
8
17