Volume; Headset Jack 1/8; Speaker - Xblue Networks WiOS Setup Manual

WiOS
(Left Side)

Volume

The volume bar is used to increase or decrease the receiver, ringer, speaker and
headset volumes.
(Left Side)
Headset Jack
The headset becomes active when it is plugged in. However, for proper operation the
feature code f [9] + [#] may be required. When a headset is plugged into the
handset, the speakerphone becomes disabled.
Volume Bar
(Right Side)

Speaker

The Speaker Button is used to active the Speakerphone on an idle or busy handset
- 10 -
Specifications
Frequency Range
Electrical Specification (Handset)

Headset Jack 1/8

inch (2.55 mm)
Lamp Cadence (Handset)
Beep / Ringer Cadence (Handset)
Frequency Range 2.4 to 2.4835 GHz
Operating 90
Channels
Battery Rechargeable Nickel Metal Hydride
Power Rating 3.6 V DC – 700 mAh
Stand-by Time Up to 160 hours
Talk Time Up to 9 hours
Line of Sight Up to 250 feet
2 2
Ft Up to 62,500 ft
Dark Line or Intercom is idle, or the feature is not active
Lit Feature is active
Slow 0.5 seconds on, 0.5 seconds off, repeating
Fast 0.1 seconds on, 0.1 seconds off, repeating
I-Use 1.85 seconds on, 0.05 seconds off, 0.05 seconds on,
0.05 seconds repeating
Key Tone 50 milliseconds
Single Beep 500 milliseconds
Double Beep 250 milliseconds on, 250 milliseconds off, 250 milliseconds
on, then off
Intercom Ring 300 milliseconds on, 400 milliseconds off, 300 milliseconds
on, 2 seconds off repeating
CO/Trunk Ring 1 second on, 2 seconds off, repeating
Hold Recall Ring 300 milliseconds on, 400 milliseconds off, repeating
WiOS
35 -
-