Preoperation Checks; Fuel; Controls; Engine - Yamaha F200 Owner's Manual

EMU27102

Preoperation checks

EWM00080
WARNING
If any item in the preoperation check is not
working properly, have it inspected and
repaired before operating the outboard
motor. Otherwise an accident could occur.
ECM00120
CAUTION:
Do not start the engine out of water. Over-
heating and serious engine damage can
occur.
EMU27111

Fuel

Check to be sure you have plenty of fuel for
G
your trip.
Make sure there are no fuel leaks or gaso-
G
line fumes.
Check fuel line connections to be sure they
G
are tight (if equipped Yamaha fuel tank or
boat tank).
Be sure the fuel tank is positioned on a se-
G
cure, flat surface, and that the fuel line is not
twisted or flattened, or likely to contact
sharp objects (if equipped Yamaha fuel
tank or boat tank).
EMU27130

Controls

Check throttle, shift, and steering for proper
G
operation before starting the engine.
The controls should work smoothly, without
G
binding or unusual free play.
Look for loose or damaged connections.
G
Check operation of the starter and stop
G
switches when the outboard motor is in the
water.
EMU27150

Engine

Check the engine and engine mounting.
G
Look for loose or damaged fasteners.
G
Check the propeller for damage.
G
Check that the battery is in good condition
G
and the battery connections are secure.
EMU27163

Checking the engine oil level

1. Put the outboard motor in an upright po-
sition (not tilted).
2. Remove oil dipstick and wipe it clean.
3. Completely insert the dipstick and re-
move it again.
4. Check the oil level using the dipstick to be
sure the level falls between the upper and
lower marks. Fill with oil if it is below the
lower mark, or drain to the specified level
if it is above the upper mark.
1. Oil dipstick
2. Lower level mark
3. Upper level mark
NOTE:
Be sure to completely insert the dipstick into
the dipstick guide.
EMU30021

Filling fuel

EWM00060
WARNING
Gasoline and its vapors are highly flam-
mable and explosive. Keep away from
sparks, cigarettes, flames, or other sourc-
es of ignition.
1. Remove the fuel tank cap.
2. Carefully fill the fuel tank.
Operation
30