Software Configuration - CNET CAR-854 User Manual

Software Configuration

5.1
The DSL device is an ADSL2+ router. When you power on the device, the system will
boot up and connect to ADSL automatically. The system provides a PVC for bridge test by
default. The default configurations for the system are listed below.
LAN IP address: 192.168.1.1, NetMask:255.255.255.0
UART setting: 115200bps, 8 bits, no parity, 1 stop bit, no flow control.
VPI/VCI for ATM: 5/35.
ADSL Line mode: Auto-detect.
User can change settings via WEB browser. The following sections describe the set up
procedures. Please set your PC's Ethernet port as follow:
IP address: 192.168.1.XXX
NetMask:255.255.255.0
Access the Web Console:Start your web browser.
Type the Ethernet IP address of the modem/router on the address bar of the browser.
Default IP address is 192.168.1.1.
The Enter Network Password dialog box appears. Type the user name and password and
then click OK.(default user name : admin; default password : admin)
Once you have connected to ADSL2+ router. You will see the status page.
This page displays the ADSL modem/router's current status and settings. This information
is read-only except for the PPPoE/PPPoA channel for which user can
connect/disconnect the channel on demand. Click the "Refresh" button to
update the status.
Connect / Disconnect
The two buttons take effect only when PVC is configured as PPPoE/PPPoA mode. Click
Connect/Disconnect button to connect/disconnect the PPP dial up link.
CAR-854 Wireless b/g ADSL 2/2+ Modem Router
- 24 -
User Manual