Chicago Electric 42654 Assembly And Operating Instructions Manual page 8

To Install A Saw Blade:
1. Caution: Prior to installing the Saw Blade (70), make sure the Compound Miter
Saw is disconnected from its electrical power source.
Caution: Never use a Saw Blade larger or smaller in diameter than 8-1/4", and
2.
rated less than 4,500 RPM operation.
3. NOTE: This procedure requires the use of the Deep Socket Wrench and Clip Washer
Wrench tool accessories. (See Figure C.)
EXHAUST PORT
FIXED BAR
(#34)
LONG SCREW
(#37)
4. Insert the two prongs of the Clip Washer Wrench into the two holes in the Clip Washer
(71), and hold the Clip Washer in place to prevent the Shaft (62) from turning. (See
Figures C, D, and Assy. Diagram.)
5. Use the Deep Socket Wrench to unscrew and remove the Bolt (73), Washer (72),
and Clip Washer (71). (See Figures C, D, and Assy. Diagram.)
For technical questions, please call 1-800-444-3353.
SKU 42654
DEEP
SOCKET
WRENCH
HEX SCREW
(#45)
CLIP WASHER
(#71)
CLIP
WASHER
WRENCH
FIGURE C
FRAME (#50)
HEX SCREW (#45)
BOLT (#73)
WASHER (#72)
FIGURE D
REV 01/05
Page 8