Chicago Electric 42654 Assembly And Operating Instructions Manual page 7

1/2"
MOUNTING
HOLE
SUPPORT FOOT
(#10)
3. Use the two mounting holes located on the Support Feet (10) of the Compound
Miter Saw as a template, and mark the two points at which two holes will be drilled
through the workbench. Then, temporarily set the Compound Miter Saw aside.
(See Figure B, and Assy. Diagram.)
4. With a drill and a 1/2" drill bit (not provided), drill the two holes downward through
the top of the workbench.
5. Align the two mounting holes in the Support Feet (10) with the two previously drilled
holes in the workbench. Then secure the Compound Miter Saw to the workbench,
using two 1/2" bolts of appropriate length, two lock washers, and two nuts (not
provided).
NOTE: Should you choose to use clamps (instead of bolts) to secure the Compound
6.
Miter Saw to the workbench, make sure the clamps (not provided) are of sufficient
size and strength to hold the Compound Miter Saw in place.
For technical questions, please call 1-800-444-3353.
SKU 42654
CLIP SCREW
(#25)
ANGLE SCALE
CLIP SCREW
(#25)
LOCATION
BOARD (#23)
BASE (#12)
1/2"
MOUNTING
HOLE
FIGURE B
Page 7