Do not force tool. It will do the job better and more safely at the rate for which it was intended. Do not use inappropriate attachments in an attempt to exceed the tool capacity. REV 01/01; 12/06; 02/07 SKU 42597 Page 2...
Page 3
18. Do not operate tool if under the influence of alcohol or drugs. Read warning labels on prescriptions to determine if your judgment or reflexes are impaired while taking drugs. If there is any doubt, do not operate the tool. SKU 42597 Page 3...
Page 4
Using the supplied Hex Key Wrench, loosen, but do not remove Screw (4). Slide the blade (teeth down) into the blade holder as far as possible. Tighten Screw (4). REV07f SKU 42597 Page 4...
Check that there is enough space under and behind the workpiece for the reciprocation blade. Be sure that you will not be cutting through any electrical wires or your workbench. Do not put side-to-side pressure on the blade as it may break. SKU 42597 Page 5...
Page 6
With the blade in motion, place it against the stock to be cut. Press down on the Saw to help it cut. Do not use too much force, only enough to keep the Saw cutting. SKU 42597 Page 6 REV 09/01...
Brush should be replaced by a qualified technician. The Carbon Brush can be accessed for evaluation or replacement by a qualified technician, by removing the Brush Holder (44) atop the Left and Right Body (49 and 50). SKU 42597 Page 7 REV 09/01...
TECHNICIANS AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO. SKU 42597 Page 9...