Choke Cable Adjustment; Reverse Gate Mechanism Inspection; Fuse Replacement - Yamaha EXCITER SE Owner's Manual

4
M
AINTENANCE

CHOKE CABLE ADJUSTMENT

Pull the choke knob out until it stops.
Release the knob. The knob should not
move. If it moves back on its own, tight-
en the friction adjustment slightly. If the
knob is difficult to move, loosen the fric-
tion adjustment slightly.
REVERSE GATE MECHANISM
INSPECTION
1. Remove the engine stop switch lan-
yard and ignition key.
2. Put the throttle lever in the idle posi-
tion (otherwise the shift lever will not
move).
3. Push the shift lever to Forward from
the Neutral position while a second
person observes shift gate move-
ment from outside the boat. The
shift gate should lift completely to
the stops.
4. Pull the shift lever back from
Forward through
Reverse. The observer shouldcheck
& C
ARE
for proper movement of the shift
gate. The gate should drop down
over the nozzle to the stops.
If reverse gate does not operate
smoothly or correctly, ask your autho-
rized Yamaha Jet Boat dealer for ser-
vice.

FUSE REPLACEMENT

➀
Ignition coil holder
➁
Grommet
The fuse is in the electrical box. To
replace the fuse, unscrew the cap and
pull out the fuse holder connected to
two red leads. Open the fuse holder
and replace the fuse.
Accessory Fuse
➀
Fuse (20A)
➁
Accessory lead
The fuse is on the accessory battery
lead wire (red with black stripe). To
replace the fuse, open the fuse box
Neutral to
and replace the fuse.
4-14
➂
➃
➀
➁
Fuse (10A)
Fuse holder