Yamaha EXCITER SE Owner's Manual page 52

3
O
PERATION
_________________
NOTE:
Before the first start-up, remove the
fuel tank filler cap to release any built-
up pressure in the tank because of fuel
expansion.
3) Attach the lanyard clip to your PFD.
Install the lanyard lock plate on the
engine stop switch by pushing the
lock plate groove over the nut
beneath the knob. Be sure the lan-
yard is not wrapped around the
steering wheel or tangled in the
controls.
➀
➁
➀
Engine stop switch
➁
Lock-plate with lanyard
_________________
NOTE:
It is not possible to start the engine
with the lock-plate removed from the
engine stop switch. However, the
starter motor will turn the engine over.
4) Pull the choke knob all the way out.
_________________
NOTE:
● It may be necessary to hold the
choke knob completely pulled out
when starting a very cold engine.
● After the engine has warmed up,
push the choke knob in gradually.
The choke should not be used when
the engine is warm.
3-12