Setting The Original - Panasonic KX-MB2010FR Operating Instructions Manual

2. Preparation

2.5 Setting the original

2.5.1 Using the scanner glass
1
Open the document cover (A).
2
Place the document FACE DOWN on the scanner
glass (B), aligning the top left of the document with
the corner where the
3
Close the document cover.
Note:
R Confirm that there are no documents in the automatic
document feeder (KX-MB2010/KX-MB2025/
KX-MB2030 only).
R Place the original onto the scanner glass gently. To
avoid malfunction, do not press down too firmly.
R If the original is a thick book, do not close the
document cover.
R Confirm that any ink, paste or correction fluid has
dried completely.
R Effective scanning area is shown by the shaded area:
Effective scanning area
4 mm
289 mm
20
A
B
mark is positioned.
4 mm
208 mm
4 mm
4 mm
2.5.2 Using the automatic document feeder
(KX-MB2010/KX-MB2025/KX-MB2030 only)
A
1
Insert the document (up to 20 pages) FACE UP into
the feeder until a single beep is heard.
2
Adjust the width of the document guides (A) to fit the
actual size of the document.
Note:
R Confirm that there are no documents on the scanner
glass.
R Confirm that any ink, paste or correction fluid has
dried completely.
R Remove clips, staples or other fasteners.
R Do not insert the following types of documents (Make
a copy of the document using the scanner glass and
set the copy instead.):
– Chemically treated paper such as carbon or
carbonless duplicating paper
– Electrostatically charged paper
– Badly curled, creased or torn paper
– Paper with a coated surface
– Paper with printing on the opposite side that can
be seen through the other side, such as newsprint
R The total height of the documents when laid flat, must
be less than 4 mm. If the documents exceed the
capacity of the automatic document feeder, they may
fall or cause a jam in the feeder.
R To set a document with a width of less than 210 mm,
we recommend using the scanner glass to copy the
original document onto A4 or letter-size paper, then
setting the copied document for better results.
R Do not set documents that do not satisfy the
requirements of size and weight. Make a copy of the
document using the scanner glass and set the copy.
R Available document size, document weight and
effective scanning area are as follows: