Panasonic KX-MB2010FR Operating Instructions Manual page 66

8. Programmable Features
Feature/Code
Sending a fax at a specific
time
MBNM4NM1NM2N
Setting the Error Correction
Mode (ECM)
MBNM4NM1NM3N
Setting the connecting tone
MBNM4NM1NM6N
Setting the maximum fax
speed
MBNM4NM1NM8N
Setting auto reduction
feature
MBNM4NM3NM2N
66
Selection
This feature allows you to take advantage of low-cost calling hours offered by
your telephone company. This feature can be set up to 24 hours in advance of
the desired time.
M0N "OFF" (default)
M1N "ON"
To send a document:
1. If the MFaxN light is OFF, turn it ON by pressing MFaxN.
2. Set the original (page 20).
3. If necessary, change the resolution (page 43) and the contrast (page 43).
4. MMenuN A MBNM4NM1NM2N
5. Press M1N to select "ON". A MSetN
6. Enter the fax number.
R To enter an item using one-touch dial feature and phonebook, see step
3 on "6.3.1 Using the scanner glass", page 45. (When using phonebook,
you do not have to press MPhonebookN before pressing MCN or MDN.)
7. MSetN
8. Enter the transmission start time.
R If you selected 12-hour time entry (page 22), press MHN repeatedly to
select AM or PM.
R If you selected 24-hour time entry (page 22), the time is set using 24-hour
time entry.
9. When using the scanner glass, press MSetN. A MStartN
When using the automatic document feeder, press MSetN.
R The document will be fed into the unit and scanned into memory. The
unit will then send the data at the specified time. You cannot use this
feature for another fax transmission until the former sending is
completed.
Note:
R To cancel this setting after programming, press MStopN while the unit is idle,
and then press MSetN.
This feature is available when the sending / receiving fax machines are ECM
compatible.
M0N "OFF": Deactivates this feature.
M1N "ON" (default): Fax transmission / reception will be carried out so that the
errors do not occur.
If you often have trouble when sending faxes, this feature allows you to hear
connecting tones: fax tone, ring back tone and busy tone. You can use these
tones to confirm the status of the other party's machine.
M0N "OFF": Deactivates this feature.
M1N "ON" (default): You will hear connecting tones.
Note:
R If the ring back tone continues, the other party's machine may not be a fax
machine or may have run out of paper. Check with the other party.
R The connecting tone volume cannot be adjusted.
M1N "14.4Kbps"
M2N "33.6Kbps" (default)
Note:
R The fax speed maybe lower than the selected speed depending on your line.
To receive a fax document that is longer than your recording paper.
M0N "OFF": The unit will print received documents at their original size.
M1N "ON" (default): The unit will fit received documents onto your recording
paper.