Led Back-Light; Thermo-Hygro Transmitter - La Crosse Technology WIRELESS WEATHER STATION Instruction Manual

Note : The transmitter number will only be displayed
if there is more than one transmitter detected.
3. To reset the minimum and maximum temperature
and humidity data, and the times at which they
were recorded, press the OUT key continuously
for about 3 seconds. This will reset all minimum
and maximum data recorded to the current time,
date, temperature and humidity. The current time
taken is the normal displayed time and does not
regard the time zone set for the unit.
Note : The MIN/MAX data for each transmitter needs to
be reset separately.

LED BACK-LIGHT

The back-light is automatically switched ON when any
keys are pressed. The back-light will be switched on for
approximately 9 seconds before automatically switching
OFF.

THERMO-HYGRO TRANSMITTER

The temperature and humidity are measured and
transmitted every 60 seconds.
The range of the Thermo-Hygro transmitter may be
affected by the temperature. At cold temperatures the
transmitting distance may be decreased. Please bear
this in mind when placing the transmitter.
433MHz RECEPTION CHECK
The Weather Station should receive the temperature and
humidity data within 15 minutes after set-up. If the
temperature and humidity data is not received 15
minutes after setting up (the display shows "- - -" after
checking for the transmission 3 times) please check the
following points :
1. The distance of the weather station or transmitter
should be at least 1.5 to 2 meters away from any
interfering sources such as computer monitors or
TV sets.
2. Avoid positioning the Weather Station onto or in
the immediate proximity of metal window frames.
3. Using
headphones or speakers operating on the same
other electrical
46
products such as