Positioning The Weather Station - La Crosse Technology WIRELESS WEATHER STATION Instruction Manual

signal frequency (433MHz) may prevent correct
signal transmission and reception.
4. Neighbours using electrical devices operating on
the 433MHz signal frequency can also cause
interference.
Note :
When the 433MHz signal is received correctly, do not re-
open the battery cover of either the transmitter or
Weather Station, as the batteries may spring free from
the contacts and force a false reset. Should this happen
accidentally then reset all units (see Setting up above)
otherwise transmission problems may occur.
The transmission range is about 100 m from the
transmitter to the Weather Station (in open space).
However, this depends on the surrounding environment
and interference levels. If no reception is possible
despite the observation of these factors, all system units
have to be reset (see Setting up).

POSITIONING THE WEATHER STATION

The Weather Station comes attached with removable
table stand, which provides the option of table standing
or wall mounting the unit. Before wall mounting, please
check that the outdoor temperature and humidity values
can be received from the desired locations.
mount :
1. Fix a screw (not supplied) into
the desired wall, leaving the
head extended out about 5mm.
2. Remove the stand from the
Weather Station by pulling it
away from the base and hang it
onto the screw. Remember to
ensure that it locks into place
before releasing.
47
To wall