Table of Contents
Advertisement
When unpacking, check to make sure all the parts shown on the Parts List on page 14
are included. If any parts are missing or broken, please call Harbor Freight Tools at the
number shown on the cover of this manual as soon as possible.
NOTE: For additional information regarding the parts listed in the following pages, refer
to the Assembly Diagram on page 15.
WARNING! Always make sure the Power Cord (14) of the Belt Sander is
unplugged from its electrical outlet prior to assembly, adding any accessories, or
making any adjustments to the tool.
To Remove/Install A Sanding Belt:
1.
Pull out on the Tension Lever of the Front Wheel Frame (53), and slide the Sand-
ing Belt (46) out. (See Figure D, next page.)
2.
Slide a new Sanding Belt (46) on. Then, push in on the Tension Lever of the
Front Wheel Frame (53). (See Figure D.)
SKU 90045
For technical questions, please call 1-800-444-3353.
SYMBOLOGY
Double Insulated
Canadian Standards
Association
Underwriters
Laboratories, Inc.
V ~
Volts Alternating Current
A
Amperes
No Load Revolutions
n o
xxxx/min.
per Minute (RPM)
UNPACKING
ASSEMBLY INSTRUCTIONS
Page 10
Hide quick links:
Advertisement
Table of Contents
