Table of Contents
Advertisement
COMPONENTS
Power Switch (44)
OFF
Tool
Angled Scraper (4)
Angled Cutter
Blade (501)
Half Moon Cutter Blade (503)
Large Washer (3)
Hex Wrench (505)
Figure a
aSSEMbLY INSTRUCTIONS
Read the ENTIRE IMPORTaNT
SaFETY INFORMaTION
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
FROM aCCIdENTaL
OPERaTION:
Turn the Power Switch (44) off
and unplug the tool from its
electrical outlet before
assembly.
Note: For additional information regarding
the parts listed in the following pages,
SKU 67256
ON
Spindle (5)
Sanding
(502)
Sanding
Sheets (504)
Cap Screw (1)
Small Washer (2)
(not shown):
Two replacement
Carbon Brushes (40)
TO PREVENT
SERIOUS INjURY
For technical questions, please call 1-800-444-3353.
refer to the Assembly Diagram near
the end of this manual.
1.
Turn the Power Switch off and unplug
the tool.
attachment
[angled
Scraper (4)]
Pad
2.
Place the attachment over the
Spindle (5), shoulder facing away
from the tool. Line up the holes on
the attachment with the pins on the
Spindle shoulder.
(See Figure b.)
Figure C
Attachments (with the exception of
the long Angled Cutter Blades) may
Figure b
Spindle
(5)
REV 10e
Page 8
Hide quick links:
Advertisement
Table of Contents
