2.
Set the Worktable (35) on its side, and align its mounting holes with the mounting holes
in the Table Support (36). (See Figure F.)
3.
Attach the Table Support (36) to the Worktable (35) using the Hex Screws (6), Lock
Washers (7), and Flat Washers (8). (See Figure F.)
TABLE SUPPORT (36)
4.
Position the Table Support (36) in the corresponding mounting holes located on the
side of the Base (42). (See Figure G, next page.)
5.
Place a Flat Washer (8) on the shaft of the Knob (1). Then, screw the Knob into the
threaded hole in the Base (42). (See Figure G.)
6.
Loosen the three Hex Screws (6), and adjust the Worktable (35) so there is a maximum
1
of
/
" space between the Sandpaper Pad (27) and the Worktable. Then, retighten the
16
Hex Screws. (See Figures F and G.)
SKU 38123
For technical questions, please call 1-800-444-3353.
FLAT WASHER (8)
LOCK WASHER (7)
HEX SCREW (6)
WORKTABLE (35)
FIGURE F
Page 10