Navigation In Screens; Using The Jog Dial; One Channel Or One Parameter - Tascam TM-D4000 Owner's Manual

I/O SETUP
more time will bring
once more.

2.3.2 Navigation in screens

In the screens above, there are no POD-selectable
parameters. In these cases, it is necessary to use
another method of working.
This is provided by the cursor keys and the
key beside the JOG/SHUTTLE
Use the cursor keys to move the cursor (
to field, and the key to select a value from
ENTER
one of a number of options.

2.3.3 Using the JOG dial

Sometimes there are numerical values to be set.
These can be entered using the
indicator is off and the Dial Edit
JOG/SHUTTLE
option is checked—see 3.3.7, "Dial edit").
The JOG dial can also be used to change the values
of a highlighted item which can also be edited by a
POD (in the screen above, there are no such values,
MODULE
but the screen in 2.3, "Using the PODs"
contains many such values). Note that the
can be used to control the values of a parameter that
is not in the currently active POD row.
In some screens, the
JOG
the cursor keys to move the cursor around the screen.
The instances where this can be performed are usu-
ally obvious and therefore will not be described in
detail.
In certain special screens, the outer
is used to change the function of a screen (for
instance in library screens, it changes the function of
the JOG dial from a device selector to a character
selector.
The numeric keypad may also be used for the direct
entry of numeric values in certain cases.
2 - Principles of operation—Using the PODs
to the front
ENTER
dial.
å
) from field
dial (when the
JOG
dial
JOG
dial may be used instead of
SHUTTLE wheel

2.3.4 One channel or one parameter?

The TM-D4000 provides two options for the setting
of module-based (as opposed to system-based)
parameters.
If one module (or stereo linked pair of modules) is to
have many parameters changed, at one time, the
channel is selected (see 2.3.5, "Selecting channels"
MODULE
below) and the
below:
MODULE
In fact, the "screen" is two screens
EQ/AUX/PAN
( and
processor)). Pressing the
between these two screens (see 2.3.1, "Selecting
screens" for more information on multiple screens).
Sometimes, though, it makes more sense to view and
adjust a single parameter on many modules simulta-
neously. For instance, here is the screen to adjust the
levels for Aux send 1, accessed by pressing the
AUX 1 key:
Note that again, this "screen" is actually two screens,
the first for the channels 1 through 16, and the second
for channels 17 through 32. Repeated presses of the
AUX 1 key will cycle between these two screens.
screen is used, as shown
EQ/DYN
(dynamics
key will change
MODULE
2–3