Tascam TM-D4000 Owner's Manual page 98

Tutorial–Simple recording session
4. Press MODULE then press the SEL button on either channel
9 or 10 until the Module screen showing AUX sends on the
bottom appears. Notice that repeated presses of a channel's
SEL button toggles between AUX sends and dynamic
processor controls.
5. Use the ROW CURSOR buttons under the lower right of
the LCD to move the blinking highlighted box down the
screen until it is around the on-screen controls for AUX
sends 3 through 6. The four continuous trim pots under the
LCD (called the POD) will now adjust the four on-screen
controls in the highlighted box.
6. Be sure the ST2 fader is turned up.
7. Play the drum machine and turn up the far right trim pot
until you hear reverb on the drums. This effect is going directly
to the stereo buss and will not be recorded on the DA-38.
7. Want a different kind of reverb? Press the EFFECT button in the LIBRARY section to the left of the LCD.
(Don't confuse this button with the one in the MIXING section, we'll get to that later...)
8. Use the JOG DIAL to select a different preset then use the cursor keys to move the cursor to the on-screen
RECALL button and press ENTER. A box will appear briefly on the screen confirming your selection.
9. Now press the EFFECT button in the MIXING section just above the faders. On the screen that appears,
you will be able to adjust the parameters of your selected effect.
10. Do you like your edited effect so much that you want to store your setting for later use? Press EFFECT
in the LIBRARY section, use the JOG DIAL to scroll down to an empty memory location (0-50 are read-only
presets), use the cursor keys to move the cursor to the on-screen STORE button and press ENTER. A box
will briefly appear on the screen to confirm your action.
11. To name your effect setting turn the SHUTTLE WHEEL to the left and use the cursor keys to highlight a
character and ENTER to select it. If you make a mistake the JOG DIAL will move though the naming field.
When you have the name you want turn the SHUTTLE WHEEL to the right, use the cursor keys to move the
cursor to the on-screen NAME button with an arrow pointing to the right and press ENTER.
12. Press MODULE to return to the module screen, this is the screen you will likely be using most often and
can be used as a "home base".
Tutorial T–5