Central Machinery 34951 Assembly And Operation Instructions Manual page 3

use eye anD ear prOtectiOn. Always wear ANSI-approved safety goggles.
8.
Use a full face mask if the work you're doing produces metal filings, dust or wood
chips. Wear a clean dust mask if the work creates a lot of fine or coarse dust. When
operating for extended periods of time, use approved ear protection.
9. DOn't aBuse tHe pOwer cOrD. Do not yank it to disconnect it from receptacle.
Do not move bench-mounted or floor-standing machines with the power cord in the
outlet. Keep cord away from heat, oil, and sharp edges.
secure wOrK. Use clamps or a vise to hold the work if possible. It's safer than
10.
using your hands and it frees both hands to operate the tool.
DOn't OVerreacH. Keep proper footing and balance at all times. Do not reach
11.
over or across machines that are running.
Maintain tOOls witH care. Keep belt and disc clean for better and safer per-
12.
formance. Follow instructions for lubricating and changing accessories. Inspect tool
cords periodically and if damaged, have them repaired by a qualified technician.
Keep handles dry, clean, and free from oil and grease.
13. DiscOnnect pOwer. Unplug when not in use, before servicing, and when chang-
ing accessories such as blades, bits, and cutters.
14. reMOVe aDjusting Keys anD wrencHes. Make it a habit to check that
keys and adjusting wrenches are removed from the tool or machine work surface
before plugging it in.
aVOiD unintentiOnal starting. Be sure the switch is in the OFF position
15.
when not in use and before plugging in.
stay alert. Watch what you are doing, use common sense. Don't operate any
16.
tool when you are tired.
cHecK DaMageD parts. Before using any tool, any part that appears damaged
17.
should be carefully checked to determine that it will operate properly and perform
its intended function. Check for alignment of moving parts, binding of moving parts,
breakage of parts, mounting, and other conditions that may affect its operation.
Any part that is damaged should be properly repaired or replaced by an authorized
service center unless otherwise indicated elsewhere in the instruction manual. Have
defective switches replaced by a qualified technician. Don't use the tool if switch
does not turn on and off properly.
18. replaceMent parts anD accessOries. When servicing, use only identical
replacement parts. Only use accessories intended for use with this tool. Approved
accessories are available from Harbor Freight Tools.
19. DO nOt Operate tOOl if unDer tHe influence Of alcOHOl Or Drugs.
Read warning labels on prescriptions to determine if your judgment or reflexes are
impaired while taking drugs. If there is any doubt, do not operate machine.
for technical questions, please call 1-800-444-3353.
SKU 34951 Page 3