Makita GA7010C Instruction Manual
Hide thumbs
Also See for GA7010C:
- Instruction manual (80 pages) ,
- Technical information (6 pages) ,
- Instruction manual (76 pages)
Table of Contents
Advertisement
Quick Links
Download this manual
See also:
Instruction Manual
Advertisement
Table of Contents
Related Manuals for Makita GA7010C
Summary of Contents for Makita GA7010C
- Page 1 INSTRUCTION MANUAL Angle Grinder GA7010C GA7010CF GA9010C GA9010CF 005003 DOUBLE INSULATION WARNING: For your personal safety, READ and UNDERSTAND before using. SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
-
Page 2: Specifications
The tool should be connected only to a power supply of Responsible manufacturer: the same voltage as indicated on the nameplate, and Makita Corporation Anjo Aichi Japan ENA100-1 can only be operated on single-phase AC supply. They are double-insulated in accordance with European... - Page 3 Keep work area clean and well lit. Cluttered and of the power tool in unexpected situations. dark areas invite accidents. 14. Dress properly. Do not wear loose clothing or Do not operate power tools in explosive jewellery. Keep your hair, clothing, and gloves atmospheres, such as in the presence of away from moving parts.
-
Page 4: Additional Safety Rules
tool is maintained. 20. Do not touch the workpiece immediately after ENB031-6 operation; it may be extremely hot and could burn your skin. ADDITIONAL SAFETY RULES 21. Position the tool so that the power cord Always use eye and ear protection. Other always stays behind the machine during personal protective equipment such as dust operation. -
Page 5: Electronic Function
ASSEMBLY Switch action 1. Switch trigger CAUTION: 2. Lock lever Always be sure that the tool is switched off and • unplugged before carrying out any work on the tool. Installing side grip (handle) 1. Side grip 005005 CAUTION: Before plugging in the tool, always check to see •... - Page 6 aligned with the notch on the bearing box. Then rotate For Australia and New Zealand the wheel guard around to the position shown in the 1. Lock nut figure. Tighten the lever to fasten the wheel guard. If the 2. Depressed lever is too tight or too loosen to fasten the wheel guard, center loosen or tighten the screw to adjust the tightening of the...
-
Page 7: Operation
For Australia and New Zealand Mount the inner flange onto the spindle. Fit the cut-off wheel on over the inner flange. Mount the outer flange on the wheel and screw the lock nut with its protrusion facing downward (facing toward the wheel). - Page 8 Only use accessory or attachment for its stated purpose. If you need any assistance for more details regarding these accessories, ask your local Makita Service Center. Wheel guard (Wheel cover) • Inner flange • Depressed center wheels •...
- Page 12 Makita Corporation Anjo, Aichi, Japan 884532C229...