Chrono Mode; Timing Function - TAG Heuer AQUARACER CALIBRE S REGATTA User Manual

CHRONO MODE

The Aquaracer Calibre S Regatta provides optimal readability of the measured times by indicating
them with the full-size watch hands:
– the hour hand indicates the measured hours,
– the minute hand indicates the measured minutes,
– the seconds hand indicates the measured seconds,
– the right counter indicates the measured tenths of a second,
– the left counter indicates "Chrono".
To move to CHRONOGRAPH mode, press the crown once. If the chronograph has not been reset to
zero, the last measured time is displayed.
Moving from TIME mode to CHRONO mode and setting the chronograph to zero
Press the crown to move from TIME mode to CHRONO mode (fig. 3).
Press B to set the chronograph to zero (fig. 4).
The hands
The hour, minute and seconds hands, as well as the right counter, are all positioned at zero. The left
counter indicates CHRONO.
The chronometer is operated in the same way as a traditional chronometer. The only difference is
that reading the measured time is easier.
SIMPLE AND ADDITIONAL TIMING FUNCTION
This function enables the chronometer to measure one time, or several consecutive times and add
them together to show the total cumulative time.
10
To start and stop the chronograph, press A.
From TIME mode
1. Move to CHRONO mode: press crown
2. Set to zero: push B
3. Start time 1: push A (START)
4. End time 1: push A (STOP)
> Read measured time 1
5. Start time 2: push A (START)
6. End time 2: push A (STOP)
> Read time 1 + time 2
etc.
7. Reset to zero: push B
Push button A
= Start
Example: Measured time: 9 hours, 5 min, 55 sec, 6/10
Note: Whenever you wish, you can display the current time in TIME mode by briefly pressing the
crown. This will not interrupt the chronograph operation. A and B have no function in this mode.
Press the crown again to return to CHRONO mode which indicates the time being measured.
Push button A
= Stop
Push button B
= Split / Reset
ths
11
11