TECHWOOD DVDC-95 Owner's Manual page 23

Audio set-up Selecting Digital Audio output
Each DVD disc has a variety of audio output options.
Set the player's Digital Audio Output according to the
type of audio system you use.
Playback
Disc Dolby Digital/ Stream/PCM
PCM
96 kHz
PCM
Linear PCM
DVD
DTS DVD
Not Output
Dolby Digita
l Dolby Digital
DVD
bit Stream
MPEG DVD
PCM
Audio CD
PCM
DTS Audio CD
DTS bit Stream DTS bit Stream
OUTPUT
PCM only
PCM PCM
DTS bit Stream Not output
Dolby Digital PCM
bit Steam
MPEG bit Steam PCM
PCM PCM
DTS bit Stream
Press SETUP in stop or playback mode
At the SETUP screen, press
Audio Output and press
Disc Audio
Disc Subtitle
Disc Menu
Rating
Password
TV Aspect
Menu Language
TV Output Select
Pseudo PAL
Digital Audio Output
5.1 Speaker Setup
Press to select the desired output and press
ENTER.
Disc Audio
Disc Subtitle
Disc Menu
Rating
Password
TV Aspect
Menu Language
TV Output Select
Pseudo PAL
Digital Audio Output
5.1 Speaker Setup
When connecting this DVD changer to a receiver or other equip-
ment using a digital cable (coax or optical), you must select an
audio output on the DVD changer that corresponds to the type of
receiver being used.
DOLBY DIGITAL/PCM:
are connecting the DVD changer with a digital cable (coax or opti-
cal) to a receiver equipped with DOLBY DIGITAL (AC-3) surround
sound but not equipped with DTS.
Stream/PCM:
Select this audio output setting if you are connect-
ing the DVD changer with a digital cable (coax or optical) to a
receiver equipped with DOLBY DIGITAL and DTS.
Note:
Use Stream/PCM setting when connecting to Techwood
A/V receivers DDR94 and DDR95.
PCM:
Select this audio output setting if you are connecting the
DVD changer with a digital cable (coax or optical) to an amplifier
or other equipment equipped only with a linear PCM input or to a
MD recorder or DAT deck.
Notes
If you connect this DVD changer to a receiver or other equipment with a
digital cable (coax or optical) and the receiver does not have a built-in
digital decoder, a very loud noise may be produced which can perma-
nently damage the speakers.
Only use a digital cable (coax or optical) if your receiver has a built-
in Dolby Digital decoder.
DVD discs recorded in DTS can only be played back in DTS format if the
DVD changer is connected to a receiver with a built-in DTS decoder.
Also, the digital audio output on the DVD changer must be set to
"Stream/PCM" to playback in DTS mode.
If you connect this DVD changer to a regular stereo or use analog audio
cables to connect to a surround sound receiver, any audio output setting
may be selected.
23
to select Digital
.
DOLBY
/PCM
DIGITAL
Stream/PCM
PCM
DOLBY
/PCM
DIGITAL
Stream/PCM
PCM
Select this audio output setting if you