Caution For Ac Mains Lead; Before Use - Panasonic SC-HTX5 Operating Instructions Manual

Caution for AC Mains Lead Safety precautions
For your safety, please read the following text carefully.
This appliance is supplied with a moulded three pin mains plug for
your safety and convenience.
A 5-ampere fuse is fitted in this plug.
Should the fuse need to be replaced please ensure that the
replacement fuse has a rating of 5-ampere and that it is approved by
ASTA or BSI to BS1362.
Check for the ASTA mark
fuse.
If the plug contains a removable fuse cover you must ensure that it is
refitted when the fuse is replaced.
If you lose the fuse cover the plug must not be used until a
replacement cover is obtained.
A replacement fuse cover can be purchased from your local dealer.
CAUTION!
IF THE FITTED MOULDED PLUG IS UNSUITABLE FOR THE
SOCKET OUTLET IN YOUR HOME THEN THE FUSE SHOULD
BE REMOVED AND THE PLUG CUT OFF AND DISPOSED OF
SAFELY.
THERE IS A DANGER OF SEVERE ELECTRICAL SHOCK IF
THE CUT OFF PLUG IS INSERTED INTO ANY 13-AMPERE
SOCKET.
If a new plug is to be fitted please observe the wiring code as stated
below.
If in any doubt please consult a qualified electrician.
IMPORTANT
The wires in this mains lead are coloured in accordance with the
following code:
Blue: Neutral, Brown: Live.
As these colours may not correspond with the coloured markings
identifying the terminals in your plug, proceed as follows:
The wire which is coloured Blue must be connected to the terminal
which is marked with the letter N or coloured Black or Blue.
The wire which is coloured Brown must be connected to the terminal
which is marked with the letter L or coloured Brown or Red.
WARNING: DO NOT CONNECT EITHER WIRE TO THE EARTH
TERMINAL WHICH IS MARKED WITH THE LETTER E, BY THE
EARTH SYMBOL OR COLOURED GREEN OR GREEN/YELLOW.
THIS PLUG IS NOT WATERPROOF–KEEP DRY.

Before use

Remove the connector cover.
How to replace the fuse
The location of the fuse differ according to the type of AC mains plug
(figures A and B). Confirm the AC mains plug fitted and follow the
instructions below. Illustrations may differ from actual AC mains plug.
1. Open the fuse cover with a screwdriver.
Figure A
2. Replace the fuse and close or attach the fuse cover.
Figure A
Fuse
(5 ampere)
4
RQT9478
or the BSI mark on the body of the
Figure B
Fuse cover
Figure B
Fuse
(5 ampere)
Placement
Set the system up on an even surface away from direct sunlight,
high temperatures, high humidity, and excessive vibration. These
conditions can damage the system and other components, thereby
shorten the system's service life.
Do not hang from or climb on the system. This may result in serious
injury.
Place the television properly on the system. Use the Fall-prevention
band to prevent the television from falling over and causing serious
damage or injury.
Do not place items heavier than the recommended weight on the
system or the shelves.
Be careful not to get hit by the protruded TV.
When you use a stand with a rotating function, install it so it does not
protrude from the top plate of the rack and do not put hands or objects
within the rotation range.
When you use a stand with a rotating function, install the rack keeping
the distance from the wall so the TV does not hit the wall.
Do not apply oil on the casters (wheels).
Be careful not to catch your fingers when installing the rack.
Do not insert your toe into the opening at the bottom of the rack when
moving or installing the rack.
Voltage
Do not use high voltage power sources. This can overload the system
and cause a fire.
Do not use a DC power source. Check the source carefully when
setting the system up on a ship or other place where DC is used.
AC mains lead protection
Ensure the AC mains lead is connected correctly and not damaged.
Poor connection and lead damage can cause a fire or electric shock.
Do not pull, bend, or place the system on the lead.
Grasp the plug firmly when unplugging the lead. Do not move the
system if AC mains lead is still connected to socket outlet. Pulling the
AC mains lead can cause electric shock.
Do not handle the plug with wet hands. This can cause electric shock.
Remove AC mains plug from socket outlet when not using for a long
period.
Foreign matter
Do not let metal objects fall inside the system. This can cause electric
shock or malfunction.
Do not let liquids get into the system. This can cause electric shock
or malfunction. If this occurs, immediately disconnect the system from
the AC mains lead and contact your dealer.
Do not spray insecticides onto or into the system. They contain
flammable gases which can ignite if sprayed into the system.
Glass shelf
Protect the board from scratching.
Do not touch the board if they crack. Consult your dealer for
immediate replacement.
Do not damage the glass or make an impact on it.
Service
Do not attempt to repair this system by yourself. If sound is
interrupted, indicators fail to light, smoke appears, or any other
problem that is not covered in these instructions occurs, disconnect
the AC mains lead and contact your dealer or an authorized service
centre. Electric shock or damage to the system can occur if the
system is repaired, disassembled or reconstructed by unqualified
persons.
Extend operating life by disconnecting the system from the AC mains
if it is not to be used for a long time.