Panasonic SC-HTX5 Operating Instructions Manual page 9

Stabilising the television
Attach the television to the rack to prevent it from falling over.
Fixing to the rack
• Make sure to use the supplied fall-prevention screw to attach the fall-
prevention band etc. as illustrated at right. (If the fall-prevention band
is not supplied with TV, use a commercially available band to fi x.)
Attach the fall-prevention band to the prepared hole at the back
bottom of the rack.
Note
• If you fasten the screw too tightly, it goes around in circles and
the TV cannot be fi xed.
• Make sure to use the fall-prevention screw supplied with this
system.
• When you attach the fall-prevention band supplied with the TV, follow
the operating instructions for the TV.
Wire dressing cover assembly
1 Collect cables
connected to each
equipment.
• For connections with other
equipment stored in this
system, refer to "Home
Theater connections"
(➜ pages 10 to 13).
• Pull the cables of equipment
on the shelf board out of the
wire dressing hole.
(Rear
Wire
view)
dressing
hole
Setting the caster trays
Set the caster trays under all 4 casters to fi x
this system and prevent it from moving.
• When setting the caster trays, match the caster cover with the
arrow of the caster trays as illustrated below.
• At least 2 people are necessary for setting the caster trays.
Be careful not to catch your fi ngers.
• Lift the rack to remove caster trays. See page 7 about how to lift
the rack.
2 Match the end
of wire dressing
cover with the wire
dressing case.
• Match the fi xing hole of
wire dressing cover with the
protrusion of case.
• The wire dressing cover
does not have directions.
Wire
dressing
Wire
cover
dressing
case
Fixing hole Protrusion
Cover
Caster tray
Arrow
(Setup example)
The illustration is an example.
The shape may differ from the actual product.
3 Match the other
end, press and set
it until it clicks.
• If the wire dressing cover is
misaligned, move it up and
down to align the position.
Click
(Caster direction)
Make the direction of front and back casters inward so
the caster trays do not run out.
outward
inward
Fall-prevention band
Prepared
screw hole
Screw (included)
To remove
• Press and hold the end of
the wire dressing cover to
remove.
9
RQT9478