Connecting to other equipment
Ensure that the screw parts of the lens adaptor and the filter are properly tightened.
•
Note
Do not attach multiple filters at the same time.
•
If the filter is tightened too much, you may not be able to remove it. Do not tighten it too much.
•
If the filter is dropped, it may be destroyed. Be careful not to drop it when attaching it to the
•
camera.
Be careful not to get a fingerprint, dirt, etc., on the filter when it is attached, otherwise the focus
•
may be adjusted to the lens, resulting in the subject being out of focus.
Refer to the instructions for each filter for details.
•
Turn off the camera when removing the filter.
•
u
MC
"Multi-coated"
•
ND
u
"Neutral Density"
Using the External Flash (optional)
After attaching the external flash, the effective range will be increased when compared to
the camera's built in flash.
Preparations: Turn off the camera and close the built-in flash.
∫ Using the dedicated flash (DMW-FL360; optional)
1
Attach the dedicated flash to the hot
shoe A and then turn on the camera and
the dedicated flash.
Be sure to firmly secure to dedicated flash with the
•
lock ring B.
2
Press 1[
124
VQT1T39
].
‰