Advertisement
This vacuum cleaner has a motor protector bypass
valve which prevents motor overheating and
damage.
The valve opens to provide cooling air when a clog
or full bag prevents normal air flow to the vacuum
cleaner suction motor.
You will notice a change of sound as air rushes
through the valve opening.
The bypass valve may open when cleaning
new carpet due to reduced airflow caused by the
new carpet lint filling the dust bag quickly.
Note: Do not block bypass valve.
Bypass
Valve
Belt Reset
Button
This vacuum cleaner has a thermal protector which
automatically trips to protect the vacuum cleaner
suction motor. If a clog prevents the normal flow of
air to the motor, the thermal protector turns the
motor off automatically.
This allows the motor to cool in order to prevent
possible damage to the vacuum cleaner.
The motor may re-start unexpectedly when it cools.
Turn the vacuum cleaner off and unplug the mains
lead from the socket to allow the vacuum cleaner to
cool and the thermal protector in the suction motor
to reset.
Check for and remove clogs, and replace bag if
necessary (See
check and replace any clogged filters. Wait
approximately 40-50 minutes before restarting
vacuum cleaner.
The agitator drive system has built-in protection
against motor damage should the agitator jam.
If the agitator slows down or stops, the belt overload
protector shuts off the agitator motor.
The vacuum cleaner suction motor will continue to
run.
Turn off and unplug vacuum cleaner, remove
obstruction, then press
Allow 20 seconds to pass before attempting reset.
If the problem persists, have the vacuum
cleaner serviced by a qualified Panasonic
technician.
-6-
page 15). Also
.
Advertisement
