Panasonic SC-BT100 Operating Instructions Manual page 11

[SELECTOR] [X], [W]
[FM]
Numbered
buttons
[FM MODE]
[6, 5]
[:, 9]
[DISPLAY]
[OK]
[2, 1]
PTY displays
NEWS VARIED FINANCE
COUNTRY AFFAIRS POP M
CHILDREN NATIONAL INFO
ROCK M SOCIAL A OLDIES
SPORT M-O-R- M RELIGION
FOLK M EDUCATE LIGHT M
PHONE IN DOCUMENT DRAMA
CLASSICS TRAVEL TEST
CULTURE OTHER M LEISURE
ALARM SCIENCE WEATHER
JAZZ
Manual tuning
1 Press [FM] to select "FM".
This unit: Press [SELECTOR].
2 Press [6, 5] to select the
frequency.
This unit: Press [X] or [W].
≥When a radio broadcast is being received,
"TUNED" lights in the display.
≥When a stereo broadcast is being received, "ST" lights in
the display.
To start automatic tuning, press and hold [6, 5] until the
frequency starts scrolling. Tuning stops when a station is found.
Presetting stations manually
Up to 30 stations can be set.
1 Press [FM] to select "FM".
2 Press [6, 5] to select the frequency.
3 Press [OK].
"P" and "M" begin to flash.
4 Press the numbered buttons to enter
preset channel number.
≥To select a 1-digit number
e.g., "1": [1] [OK].
≥To select a 2-digit number
e.g., "12": [1] [2].
≥A station previously stored is overwritten when another station is stored in the
same channel preset.
Repeat steps 2 to 4 to set other stations.
Selecting the preset channels
1 Press [FM] to select "FM".
2 Press the numbered buttons to select the
channel.
≥To select a 1-digit number
e.g., "1": [1] [OK].
≥To select a 2-digit number
e.g., "12": [1] [2].
Alternatively, press [:, 9] or [2, 1] to select the channel.
RDS broadcasting
The unit can display the text data transmitted by the radio data system (RDS)
available in some areas. If the station you are listening to is transmitting RDS
signals, "RDS" will light up on the display.
≥RDS displays may not be available if reception is poor.
When "FM" is selected
Press [DISPLAY] to display the text data.
Each time you press the button:
PS: Program service
PTY: Program type ( left)
OFF: Frequency display
§
"M-O-R- M"=Middle of the road music
If noise is excessive
When "FM" is selected
Press [FM MODE] to display "MONO".
NOTE
≥Press the button again to cancel the
mode.
≥The mode is also canceled when you change the frequency.
≥This setting can be preset for each broadcasting station. When "MONO"
appears follow procedures 3 and 4 in Presetting stations manually
( above).
e.g., Display
TUNED
TUNED ST
e.g., Display
M
e.g., "12"
e.g., "12"
e.g., Display
TUNED MONO
RQT9161
11