Adjustment Instructions - Troy-Bilt TB45E Operator's Manual

ADJUST SHAFT LENGTH
1. Grip shaft firmly.
2. Push shaft release button (A) and move motor hous-
ing forward or backward to desired length. (Fig. 5)
NOTE: Shaft may be adjusted in trimming or edging mode.
A
EDGING CONVERSION
1. Grip shaft firmly.
2. Push edge button (B) and rotate handle assembly
until an audible click is heard. (Fig. 6 & Fig. 7)
3. Adjust assist handle as required.

ADJUSTMENT INSTRUCTIONS

Fig. 5
B
Fig. 6
Fig. 7
ADJUST THE ASSIST HANDLE
NOTE: The assist handle is attached to the shaft but has
been turned under for packing
1. Loosen adjustment knob and rotate handle to the top
of shaft (Fig. 8).
2. Tighten adjustment knob securely.
STARTING
1. Before starting the grass-trimmer for the first time,
check that the nylon lines touch or pass over the line-
cutting blade. If they are not long enough, press the
bump knob and, at the same time, pull the nylon lines.
(Fig. 9).
2. Connect the correct extension cord to the string trim-
mer power cord per the instructions in Section 5-1
Connect the cord.
3. Make sure the length of grass trimmer and position of
assist handle is most comfortable before use, adjust
the length of grass trimmer by pressing the shaft
adjustment button, adjust the height of assist handle
by loosening the adjustment knob.
9
Fig. 8
Fig. 9