Assembly Instructions - Troy-Bilt TB75SS Operator's Manual

INSTALLING AND ADJUSTING THE D-HANDLE
Install
1. Remove the screws and bottom clamp piece that
were installed on the D-handle for shipping.
2. Place D-handle the over the shaft housing and onto
the bottom clamp (Fig. 1). Place it a minimum of 6
inches (15.24 cm) from the end of the shaft grip.
3. Start screws with a large Flat-head or T-25 Torx
screwdriver. Do not tighten until you make the
handle adjustment.
Adjust
4. If the D-handle was pre-installed, loosen the screws
on the handle just enough to move it.
Shaft Grip (4) Screws
Shaft
Housing
On/Off Stop Control
Minimum 6 inches
(15.24 cm)
D-Handle
Bottom Clamp
5. While holding the unit in the operating position,
manuever the D-handle to the location that provides
you the best grip.
6. Tighten the clamp screws evenly, until the D-handle
is secure.
INSTALLING THE CUTTING ATTACHMENT SHIELD
Use the following instructions if the cutting attachment
shield on your unit is not installed or if you ever need to
re-install it.
WARNING:
cutting attachment shield in place to
prevent serious personal injury.
Install on a Straight Shaft (TB75SS)
1. Slide the cutting attachment shield into the shield
mount on the cutting attachment. Align the screw
holes in the shield with the holes in the cutting
attachment (Fig. 2).
2. Place a hex lock nut into one of the three recessed
holes on the top of the cutting attachment shield (Fig 3).
3. Install a screw into the hole from the bottom of the
cutting attachment shield and screw it into the nut
installed in step 2 (Fig 3). Do not tighten.
4. Repeat steps 2 and 3 until all three screws have
been started, then tighten securely.

ASSEMBLY INSTRUCTIONS

Fig. 1
Never operate the
trimmer without the
Shaft Housing
Cutting Attachment
Install on a Curved Shaft (TB25CS)
1. Place the cutting attachment shield onto the shaft
housing above the clamp assembly (Fig. 4).
2. Push the cutting attachment shield down to the top of
the cutting attachment assembly and then rotate the
cutting attachment shield until the screw holes align
and the guard fits into the recessed pocket (Fig. 4).
3. Install the screws with a Phillips screwdriver (Fig. 5).
Clamp
Assembly
Recessed
Pocket
Cutting
Attachment
Assembly
Cutting
Attachment
Shield
Shield Mount
Fig. 2
Hex Lock
Nut
Recessed Holes
Screws (3)
Fig. 3
Cutting
Attachment Shield
Fig. 4
(4) Screws
Fig. 5
7