Storing Tv Broadcasts In Your Vcr; To Change The Rf Output Channel; Plug In Auto Tuning - Panasonic NV-SJ230AM Operating Instructions Manual

To Change the RF output Channel

In some rare cases after tuning the TV to your VCR,
interference may be visible on the picture. To get rid of this
interference, you can manually adjust the RF output channel
a few channels up and down from the current setting. The
procedure is described below.
Operations
1 Hold down MENU button
– The VCR display changes as shown below and the
VCR picture on the TV displays this pattern.
VCR display
2 Enter the desired channel number (E21-E69) by the VCR
Channel button .
– Set the RF output channel of the VCR to [ss] (RF OFF)
when the VCR is connected to the TV via the Audio/
Video cable.
Press the VCR Channel button
21
3 Press the MENU button
4 Retune your TV to the new RF channel for the VCR.
Note:
– Even if the RF output channel has been changed, it is not
necessary to perform Auto Tuning.
6
for 5 seconds or more.
On Screen Display
Panasonic VCR
RF SELECT ≥ BG I DK
RF SELECT: END: MENU
to display [ss].
69
ss
(RF OFF)
to finish the setting mode.
Storing TV Broadcasts in Your
The VCR is fitted with its own tuner (just like a normal TV) and
can be preset to receive up to 99 TV broadcast stations.

Plug in Auto Tuning

When the VCR is turned on after connecting the aerial cable
and the mains lead, Auto Tuning starts.
CH 22
Auto tuning searches for TV stations from VHF minimum to
UHF maximum and memorizes every tuned programme
position.
– If you turn the VCR off during Auto Tuning, Auto Tuning will
stop halfway.
– If the VCR starts playback during Auto Tuning, Auto Tuning
will stop halfway.
To Cancel Auto Tuning Mid-Operation:
Press the MENU button
is cancelled.
To Restart Plug in Auto Tuning:
1 Press the EJECT button
cassette.
2 Keep the VCR Channel buttons
simultaneously for 3 seconds or more during the VCR on.
– The channel displayed on the VCR display disappears
for a moment then changes to 1.
3 Disconnect the mains lead and then reconnect it.
4 Turn off the VCR and then turn it on.
– Auto Tuning commences.
If Auto Tuning stops halfway by turning the VCR off,
playback or a power failure:
1 Disconnect the mains lead and then reconnect it.
2 Turn off the VCR and then turn it on.
– Auto Tuning commences.
VCR
AUTO TUNING
IN PROGRESS,
PLEASE WAIT.
SEARCH 21
END: MENU
during Auto Tuning. Auto Tuning
and remove the video
on the VCR pressed
Disappears 1