Connections; Tuning The Tv To Your Vcr - Panasonic NV-SJ230AM Operating Instructions Manual

Connections

This section shows you how to connect the VCR to an aerial,
TV, etc.
When the VCR is turned on after unpacking and
connecting the aerial cable and the mains lead, Plug in
Auto Tuning starts automatically.
Basic Connections
The following connections are required to record and play
back the video cassette through the TV.
TV Set (Not supplied)
2
Cable Strap
3
To mains supply
∫ To loose a Cable Strap
Push up a strap in the direction of
the arrow, pushing a Lock Tab.
Connection to a TV using the Audio/Video Input Socket:
Set the RF output channel of the VCR to [ss] (RF OFF)
when the VCR is connected to the TV via the Audio/Video
cable. (See page 6.)
TV Set (Not supplied)
Aerial Connector
2
Cable Strap
4
To mains supply
Aerial (Not supplied)
1
Aerial Connector
Aerial Input
socket
I N
VIDEO
AUDIO OUT
IN ( AV1 ) OUT RF
Aerial Output
socket
Cable Strap
Aerial (Not supplied)
1
VIDEO IN
Aerial Input
AUDIO IN
3 socket
(Not supplied)
I N
VIDEO
AUDIO OUT
IN AV1 ( ) OUT RF
Aerial Output
socket
AUDIO OUT
VIDEO OUT

Tuning the TV to Your VCR

The VCR supplies a signal to the TV via the RF coaxial cable
on channel E21-E69.
It is possible to view the video picture on your TV in the same
way that you watch TV broadcasts.
If you have connected the VCR to the TV through the Audio/
Video input sockets, then you do not need to follow the
procedure below.
When the VCR is turned on after unpacking and
connecting the aerial cable and the mains lead, Plug in
Auto Tuning starts automatically.
Notes:
– If the VCR is turned on with the aerial not connected, all
channels are skipped. Therefore, firmly connect the aerial
and then turn the VCR off and on again to execute Auto
Tuning.
– When Auto Tuning is cancelled halfway, Auto Tuning is not
executed even if the VCR is turned off and then turned on
again. In this case, see page 6 [To Restart Plug in Auto
Tuning].
Operations
1 Turn on the TV and the VCR.
2 Set the TV to an unused position which you wish to
use for your video playback.
– Tune the TV until the display shown below appears on
the screen. (Please refer to the TV manufacturers
operating instructions regarding tuning.)
– Set [RF SELECT] by pressing the Cursor buttons (21)
to select the colour TV system used by the TV set to
Lock Tab
be connected.
BG:
I:
DK:
On Screen Display
CH 22
During Plug in Auto Tuning
3 Press the MENU button
/
PAL B.G.H/SECAM B.G
PAL I
PAL D/SECAM D.K.K1
AUTO TUNING
IN PROGRESS,
PLEASE WAIT.
RF SELECT
RF SELECT:
SEARCH 21
END: MENU
After Plug in Auto Tuning
.
AUTO TUNING IS
COMPLETED.
≥ BG I DK
END: MENU
5