Printing Quality Problems - Samsung Mono Laser Printer User Manual

Printing quality problems

If the inside of the machine is dirty or paper has been loaded improperly,
you may notice a reduction in print quality. See the table below to clear the
problem.
CONDITION
If a vertical white streak or faded area appears on
Light or faded print
the page:
• The toner is not well distributed, you can
improve print quality by redistributing the toner.
See page 27. If this does not improve the print
quality, install a new toner cartridge or an
imaging unit.
• The paper may not meet paper specifications;
for example, the paper is too moist or too
rough. See page 18.
• If the entire page is light, the print resolution
setting is too low. Adjust the print resolution.
See the help screen of the printer driver.
• A combination of faded or smeared defects
may indicate that the printing cartridge needs
cleaning.
• The surface of the LSU part inside the machine
may be dirty. Clean the LSU by opening and
closing the front cover several times and if the
problem still occurs call the contact a service
representative.
• The paper may not meet specifications; for
Toner specks
example, the paper is too moist or too rough.
AaBbCc See page 18.
• The paper path may need cleaning. See
AaBbCc
"Cleaning the inside" on page 25.
AaBbCc
AaBbCc
AaBbCc
If faded areas, generally rounded, occur randomly
Dropouts
on the page:
• A single sheet of paper may be defective. Try
AaBbCc
reprinting the job.
AaBbCc
• The moisture content of the paper is uneven or
the paper has moist spots on its surface. Try a
AaBbCc
different brand of paper. See page 18.
AaBbCc
• The paper lot is bad. The manufacturing
AaBbCc processes can cause some areas to reject
toner. Try a different kind or brand of paper.
• Change the printer option and try again. Go to
printer properties, click Paper tab, and set type
to Thick Paper. Refer to the Software section
for details.
If these steps do not correct the problem, contact a
service representative.
SUGGESTED SOLUTIONS
CONDITION
White spots appear on the page:
White Spots
• The paper is too rough and a lot of dirt from the
paper falls to the inner devices within the
machine, which means the transfer belt may be
dirty. Clean the inside of your machine. Contact
a service representative.
• The paper path may need cleaning. Contact a
service representative.
If white vertical streaks appear on the page:
Vertical lines
• The surface of the LSU part inside the machine
may be dirty. Clean the LSU by opening and
closing the front cover several times and if the
problem still occurs contact a service
representative.
If the amount of background shading becomes
Black background
unacceptable:
• Change to a lighter weight paper. See page 18.
• Check the machine's environment: very dry
(low humidity) or high humidity (higher than
80% RH) conditions can increase the amount
of background shading.
• Remove the old imaging unit and install a new
one. See page 30.
• Clean the inside of the machine. See page 25.
Toner smear
• Check the paper type and quality. See page 18.
• Remove the imaging unit and install a new one.
See page 30.
If marks repeatedly appear on the printed side of
Vertical repetitive
the page at even intervals:
defects
• The imaging unit may be damaged. If a
repetitive mark occurs on the page, print a
cleaning sheet several times to clean the
cartridge. After the printout, if you still have the
same problems, remove the toner cartridge and
install a new one. See page 28.
• Parts of the machine may have toner on them.
If the defects occur on the back of the page, the
problem will likely correct itself after a few more
pages.
• The fusing assembly may be damaged.
Contact a service representative.
SUGGESTED SOLUTIONS
Troubleshooting_ 38