Table of Contents
Advertisement
Operating your Oven on Combination
Multi-Stage (Sequential) Heating
Changing the Heating Time
Oven Lamp
Repeat Feature
Stop Pad
Preheat
Caution:
There is no NON-TIP Safety Lock on Wire Rack Shelf. Take care when
removing food.
The oven can be programmed with up to 3 different
functions to operate in sequence. These can be
MICROWAVE, GRILL, CONVECTION or
COMBINATION programs.
For 2 stage programming:
Follow steps 1-3 before then enter the next heating
programme, then press Start Pad.
For 3 stage programming:
Follow 2 stage programming and enter a 3rd heating
programme before pressing Start Pad.
The heating time can be increased or decreased
during cooking by turning the timer dial.
The Oven Lamp switches off when the door is closed.
If you want to check the food, press Lamp Pad, it will
then illuminate for 10 seconds.
The Oven Lamp turns on whenever the door is
opened.
You can repeat the same heating programme if you
press Start Pad within 1 minute of the previous
programme finishing.
After 1 minute, if Start Pad is not pressed, the display
returns to "0", or goes blank if the oven door is closed.
Before heating: One tap clears the display.
During heating: One tap stops the heating cycle and
two taps clears the display.
N.B. see page 18 for operation while in Programme
Lock.
For best results on combination the oven should be
preheated. (See page 20)
It is useful to keep the oven condition fixed.
For recalling set mode see pages 11 and 13.
A
1
2
3
B
A
1
2
3
B
LAMP
START
STOP
PREHEAT
15
Advertisement
Table of Contents
