Removing The Refrigerator Doors - Samsung French Door Refrigerator User Manual

• Allow clearance to the
right, left, back and top
when installing.
This will help reduce
power consumption and
keep your energy bills
lower.
• Do not install the refrigerator where the
temperature will go below 50 ºF (10 ºC).
• Do not locate the refrigerator where it may
become wet.
when moving your refrigerator
To prevent floor damage, be sure the front
adjusting legs are in the up position (above
cAutIoN
the floor).
Refer to 'Adjusting the doors' in the
manual (on page 14).
Flat-blade screw
driver(-)
FlOORINg
For proper installation, you must place this
refrigerator on a level, hard surface that is the
same height as the rest of the floor. This surface
should be strong enough to support a fully loaded
refrigerator, or approximately165 kg.
To protect the finish of the flooring, cut a large
section of the cardboard carton and place it under
the refrigerator where you are working. When
moving the refrigerator, you need to pull and push
it straight forwards or back. Do not wiggle it from
side to side.
DA68-02649B.indd 9
B B
A A
E E
C C
D D
Control lever
REMOvINg ThE REFRIgERATOR
dOORS
If the Refrigerator is too large to pass through your
doorway easily, you can remove the refrigerator
doors.
Tools you will need (Not provided)
Philips Flat-blade
screwdriver (+) screwdriver (-)
Pliers Allen wrench
(3/16") (5mm)
Disconnect power to the refrigerator before
removing the door or drawer.
WARNING
• Be careful not to drop, damage or
scratch the door/drawer while removing
them.
• Be careful not to get injured while removing the
door/drawer.
• Reattach the door/drawer properly to avoid:
- Moisture from air leakage.
- Uneven door alignment.
- Wasting energy due to improper door seal.
Socket wrench
(10mm)
setting up _09
2012.8.30 6:39:12 PM