Adjusting The Freezer Drawer Level; Installing The Water Dispenser Line - Samsung French Door Refrigerator User Manual

AdjuSTINg ThE FREEzER
dRAwER lEvEl
Adjustment part
1. Locate the height-adjuster (
drawer. Unscrew the 8 Phillips screws ( 2 )
slightly to loosen the door.
2. Loosen the controller screw
( 3 ) with a Phillips screwdriver
(+).
3. Find the best level to align the door slope.
• After adjustment, tighten the controller screw
( 3 ) and then the philips screws.
Example) The slope is about 2 mm as shown below.
- Rotate the height adjuster to -2.0 to reduce the door slope.
Slope
Reference plane
DA68-02649B.indd 13
Freezer drawer
1 ) in the freezer
1
2
3
INSTAllINg ThE wATER
dISpENSER lINE
However, it does not sterilize or destroy
microorganisms. You may need to purchase a
water purifying system to do that. In order for the
ice-maker to operate properly, a water pressure of
138~862 Kpa is required.
Under normal conditions, a 170 cc (5.75 oz.) cup
can be filled in 10 seconds. If the Refrigerator
is installed in an area with low water pressure
(below 138Kpa), you can install a booster pump to
compensate for the low pressure.
Make sure the water storage tank inside the
Refrigerator is properly filled. To do this, press the
water dispenser lever until the water runs from the
water outlet.
Water line installation kits are available at extra cost
from your dealer.
We recommend using a water supply kit that
contains copper tubing.
Check the accessory list below.
Hex wrench
Compression fitting
Connecting to the water supply line
1. First, shut off the main water
supply.
2. Locate the nearest cold water drinking line and
install the pipe clamp and shut off valve.
cold water line
Pipe clamp
Shut off valve
Fastener
Compression nut
setting up _13
2012.8.30 6:40:12 PM