Samsung French Door Refrigerator User Manual page 14

3. Connect the water line installation kit to the shut
off valve.Connecting the water supply line to the
refrigerator.
cold water line
Pipe clamp
Shut off valve
There are several items that you need to purchase
to complete this connection.
You may find these items sold as a kit at your local
hardware store.
use copper tubing
• 6 mm copper tubing
• 6 mm compression
nut (1 pc)
• Ferrule (2 pc)
Refrigerator
Compression
Nut (6 mm)
(Assembled)
Ferrule
(Not supplied)
Copper tubing
(Not supplied)
household water supply line
1. Connect the household water line to the
assembled compression fitting fitting.
- If you are using copper tubing, slip the
compression nut ( B ) (not supplied) and
ferrule (not supplied) on the copper tubing (not
supplied) as shown.
- If you are using plastic tubing (
molded end (Bulb) of the plastic tubing ( B ) into
the compression fitting.
14_ setting up
DA68-02649B.indd 14
Water line installation kit
use Plastic tubing
• 6 mm plastic tubing
→ Molded end (bulb)
• 6 mm compression
nut (1 pc)
Plastic Tubing
(Assembled)
Compression Fitting
(Assembled)
Molded end (Bulb)
Compression nut ( B )
(6 mm) (Not supplied)
or plastic tubing ( b )
(Not supplied)
B ) , insert the
Do not use without the molded end (Bulb)
of the plastic tubing ( B ).
cAutIoN
2. Tighten the compression nut (
compression fitting.
Do not over-tighten the compression nut ( B ) .
3. Turn water on and check for any leakage.
If you find water drops or leakage in the
connection areas, turn off the main water
supply.
Check the connections and, if necessary,
tighten.
4. Flush 4 L of water through the filter before
drinking or using the water from the refrigerator.
(Flush approximately 6 minutes.)
To flush, press a large glass or cup against the
water dispenser lever.
Fill the glass, empty it into the kitchen sink after
it is filled, and then repeat.
5. After you turn on the refrigerator, let the ice
maker make ice for 1 to 2 days.
Over that period of time, throw out the first 1 or
2 buckets of ice the freezer makes to ensure all
impurities have been removed from the water
line.
Only connect the water line to a drinkable
water source.
If you have to repair or disassemble the
water line, cut off 6 mm of the plastic
tubing to make sure you get a snug, leak-
free connection.
B ) onto the
2012.8.30 6:40:14 PM