FireRock B-VENT FIREPLACE
INSTALLATION, OPERATION, MAINTENANCE and
FireRock MODELS 14030; 14036; 14042; 14048
IMPORTANT: This manual contains assembly rules, installation steps and guidelines, and use and maintenance
instructions for FireRock B‐VENT gas appliances (14000 Series). This manual must become the property of and be
reviewed by all current and future users of this product. It is the responsibility of the distributor, general contractor
and the installer of this product that the instructions in this manual are followed exactly and, further that the
allowed gas log appliance used in this product be installed in strict accordance with the gas log manufacturer's
listing and explicit installation and operation instructions.
This Listed Top Vented Gas Log Enclosure is designed for use with
Decorative Natural Gas or Propane (LP) Gas Appliances, only.
DO NOT BUILD A WOOD FIRE
WARNING: If the information in this manual is
not followed exactly, a fire or explosion may
result causing property damage, personal injury
or loss of life.
Do not store or use gasoline or any other flam‐
mable vapors or liquids in the vicinity of this or
any other appliance.
WHAT TO DO IF YOU SMELL
•
Do not try to light any appliance.
•
Do not touch any electrical switch.
•
Do not use any phone in your building.
•
Immediately call your gas supplier from a
neighbor's phone. Follow the gas supplier's
instructions.
•
If you cannot reach your gas supplier, call the
fire department.
Tested and Listed by PFS Corporation, Cottage Grove, WI USA. PFS Report Number 08‐155
THIS MANUAL MAY ONLY BE REPRODUCED IN ITS ENTIRETY
Fire Rock Products, LLC Birmingham, AL
OWNER'S MANUAL
GAS:
GENERAL INFORMATION
NOT FOR USE WITH SOLID FUEL.
The flue damper must be in the full open
position when burning the gas logs.
Massachusetts state code requires the vent
damper to be welded open or removed.
This appliance complies with National Safety and is
tested and listed to ANSI Z21.50 - 2003 as vented gas
.
fireplaces.
Installation and service must be performed by a lo-
cally certified gas service agent, licensed plumber or
the gas supplier.
Installation must conform to local codes. Check local
codes prior to installation.
In the absence of local codes, installation must conform
to current National Fuel Gas
Code, ANSI Z223.1.