Table of Contents
Advertisement
CAUTIONS
Follow the cautions below when using this copier.
1
Use of controls or adjustments or performance of procedures other than those
specified herein may result in hazardous radiation exposure.
Cautions on laser
Wave length
Pulse times
Output power
MAIN FEATURES
High-speed laser copying
Since warm-up time is zero, copying can be started immediately after the power switch is
turned on.
First-copy time is only 9.6 seconds (normal mode).
Copying speed is 12 copies/min. (AR-120E) or 15 copies/min. (AR-150E), which adapts
to business use, allowing improvement of working efficiency.
4
The fusing area is hot. Exercise care in this area when removing misfed
paper.
Do not look directly at the light source. Doing so may damage your eyes.
Do not switch the copier rapidly on and off. After turning the copier off, wait 10
to 15 seconds before turning it back on.
Copier power must be turned off before installing any supplies.
Place the copier on a firm, level surface.
Do not install the copier in a humid or dusty location.
When the copier is not used for long time, for example for consecutive holidays,
turn the power switch off and remove the power cord from the outlet.
When moving the copier, be sure to turn the power switch off and remove the
power cord from the outlet.
Do not cover the copier with a dust cover, cloth or plastic film while the power
is on. Doing so may prevent heat radiation, damaging the copier.
785 nm ±15 nm
(10.7 µs ±4 ns)/7 mm
0.2 mW - 0.03 mW
Advertisement
Table of Contents
