Two-Sided Copying - Sharp AR-205 Operation Manual

TWO-SIDED COPYING

Automatic two-sided copying can be made with this copier. For two-sided
copying from the original table, follow the procedure below. Fully automatic
two-sided copies can be made from one-sided originals if either an optional
single pass feeder (SPF) or an optional reversing single pass feeder (RSPF)
is installed. See page 60. Additionally, fully automatic two-sided copying of
two-sided originals or one-sided copying of two-sided originals can be made
if an optional reversing single pass feeder is installed. See page 62.
20
1 Place the first original face down on the original table
and close the platen cover.
2 Press the ORIGINAL TO COPY key to select one-sided to
two-sided (
3 Ensure that the desired paper tray is selected.
Paper sizes that can be used in the duplex mode are A5, A4, A4R, B4
and A3 (8-1/2" x 11", 8-1/2" x 11"R, 8-1/2" x 13", 8-1/2" x 14", and
11" x 17").
5-1/2" x 8-1/2" size paper cannot be used in the duplex mode.
The bypass tray cannot be used in the duplex mode.
4 Press the START (
The indicator will blink.
The copy will not be output until both sides have been scanned.
) copying.
) key.