Troubleshooting And Maintenance; Display Messages - Sharp AR-M150 Operation Manual

8
Chapter 8
TROUBLESHOOTING AND
MAINTENANCE
Problems related to general use of the machine, the copy function, and software
setup are explained here. Be sure to check the problem carefully before calling for
service, as many problems can be solved by the user.
If you are unable to solve the problem, turn off the main switch, unplug the power
cord from the outlet, and contact your dealer.
Note

DISPLAY MESSAGES

When the following indicators light up or blink on the operation panel or the following
alphanumeric codes appear in the display, solve the problem immediately referring
to both the table below and the indicated page.
Note
Lamp indicator
Tray
location
indicator
Error
indicator Blinks
For problems related to the printer and scanner functions, see the
online manual.
Be sure to use only genuine SHARP parts and supplies.
Indication
Display
BYPASS : ADD
PAPER
TRAY<*> : ADD
Blinks
PAPER
CLOSE PAPER
TRAY<*>
CLEAR PAPER
JAM.
SPF/RSPF JAM.
FRONT OR SIDE
COVER OPEN.
CLOSE COVERS.
CLOSE THE SPF/
RSPF COVER.
REPLACE THE
TONER
CARTRIDGE.
SYSTEM ERROR
[XX - XX] REFER
TO USER GUIDE
Cause and remedy
The indicated paper tray is not
attached, is attached incorrectly, or has
run out of paper. (The tray is indicated
in <*>.)
A paper misfeed has occurred.
Remove the misfeed as explained in
"MISFEED REMOVAL".
The cover is open. Close the cover.
The SPF/RSPF cover is open. Close the
SPF/RSPF cover.
The toner cartridge is empty. Replace
the toner cartridge with a new
cartridge. (When the indicator blinks,
the machine does not operate.)
When [L1-00] appears, the scan head
locking switch is locked. Turn off the
power, release the scan head locking
switch, and turn the power back on.
The machine will not function. Turn the
power switch off, wait about 10
seconds, and then turn on the switch
again. If this does not clear the error,
remove the power cord from the outlet,
and contact your authorised service
representative.
Page
15
79
-
82
8
83
86
-
69