Sharp AR-M150 Operation Manual page 23

Removing the document cover
To copy large originals like newspapers, remove the
document cover. To remove the cover, lift straight up
as shown. To replace the cover, do the reverse.
The SPF/RSPF cannot be removed.
Using the SPF/RSPF
• Originals that are A5 to A4 (5-1/2" x 8-1/2" to 8-1/2" x 14") and
Note
52 g/m
pages can be placed at once.
• Straighten curled originals before placing them in the document
feeder tray. Curled originals may cause misfeeds.
• Place originals horizontally.
• Before placing originals in the document feeder tray, be sure to
remove any staples or paper clips from them.
• When a copy is made, the edges will not be copied (
For the image loss, see the "SPECIFICATIONS" (p.93).
• When using the margin shift function, check the position of the
margins carefully. (p.34)
1
Make sure that an original has not been left on the document
glass.
2
Adjust the original guides to the size
of the originals.
3
Set the original(s) face up in the
document feeder tray.
The SPF/RSPF indicator on the operation
panel will light up. If this indicator does not
light up, the originals are not properly set or
the SPF/RSPF is not properly closed.
4
Select the number of copies and other copy settings, and then
press the [START] key (
• To stop copying in the middle of a run, press the [CLEAR] key (
Note
• For the copy settings, see pages 23 through 35.
2 2
to 90 g/m
(14 lbs. to 24 lbs.) can be used. A maximum of 30
).
MAKING COPIES
image loss ).
Original face up
).
3
21