Appendix; Symbols And Typographical; Conventions Used; Care - Gigaset E36 User Manual

Appendix

Appendix

Symbols and typographical

conventions used

This section explains the meaning of cer-
tain symbols and typographical conven-
tions that are used in this user guide.
~
Enter digits or letters.
The display functions currently
§Menu§
in the bottom display line are
shown in reverse video. Press
the relevant display key to
launch the function.
q
Press the top or bottom of the
control key, for example when
scrolling.
c / Q / P etc.
Press the illustrated key on the
handset.
External Calls / Internal Calls
Select one of the menu func-
tions (External Calls
Calls) from the list and
press
§OK§
¢
Audio Settings
§Menu§
Melody (example)
Press
§Menu§
using q and press
tings
Select
Ringer Melody
and press

Care

¤
Wipe the base station and handset with
a damp cloth (do not use solvent) or an
antistatic cloth.
Never use a dry cloth. This can cause
static.
14
(example)
or
Internal
.
¢ ¢
Ringer
§OK§
¢
§OK§
. Select
Audio Set-
.
§OK§
using q
.
§OK§

Contact with liquid

If the handset has come into contact with
liquid:
¤
Switch the handset off and remove
the batteries immediately.
¤
Allow the liquid to drain from the
handset.
¤
Pat all parts dry, then place the handset
with the battery compartment open
and the keypad facing down in a dry,
warm place for at least 72 hours
(not in a microwave, oven, etc.).
¤
Do not switch on the handset again
until it is completely dry.
When it has fully dried out, you will gener-
ally be able to use it again.

Questions and answers

If you have any questions about using
your phone, visit us anytime at
www.gigaset.com/customercare. The
table below contains a list of common
problems and possible solutions.
The display is blank.
1. The handset is not switched on.
¥
Press andhold the end call key
2. The battery is flat.
¥
Charge the battery or replace it
(page 4).
The handset does not respond to a key
press.
The keypad lock is activated.
¥
Press and hold the hash key
is flashing in the display.
Base
1. The handset is outside the range of the
base station.
¥
Move the handset closer to the base.
2. The base station is not switched on.
¥
Check the base station mains adapter.
Handset does not ring.
The ringtone is switched off.
¥
Activate the ringtone (page 12).
!
a
.
#
(page 7).