Registering The Handset - Gigaset 3000 Micro Operating Instructions Manual

Registering the handset

You can change the display language
doing this, switch your handset off and then on again.
You must register a new handset at the base station before
you can make any telephone calls. When you switch on your
handset, the message
Step 1:
• You must first prepare the Siemens base station:
Gigaset
3010 Micro
3010/3015
3020, 3025
3030, 3035
ISDN
models
1000/2000
models
Step 2:
• Now enter the following in the handset within one
minute:
Enter base PIN
e.g.
– To register at multiple base stations or to change base
names, see page 24.
– To modify the internal call number: re-register your hand-
set at the same base, see page 24.
* English is the default factory setting
10
Preparing the base station
Press the coloured key on the base station
for approx. 10 seconds until you hear the
signal tones.
In the base station menu select registration
option and confirm.
Press the LED – flashes during registration.
See above for appropriate successor models
in the 3000 range, e.g. 3010 for 2010.
Press the display key.
Enter the base station's system PIN (fac-
tory setting: 0000) and confirm – unas-
signed internal numbers are displayed.
Enter the required call number – the base
name, e.g.
longer flashing).
Your handset is now ready for use!
*
(see page 22). After
appears.
, is displayed (no