Table of Contents
Advertisement
The polarity is indicated in/on the battery compart-
ment.
Closing the battery cover
◆
Position the cover pointing slightly downwards
and push it up until it clicks into position.
Opening the battery cover
Press below the upper curve on the battery cover
and slide down.
Step 3: Charging the batteries
To charge the batteries, place the handset in
the base/charging cradle and leave for approx. 12-
15 hours. The batteries are now fully charged. The
battery charging status is correctly displayed only
after uninterrupted charging/discharging. There-
fore you should not interrupt the charging process.
Charging is controlled electronically to prevent the
batteries from overcharging. The batteries heat up
during charging. This is normal and not dangerous.
After a time the charge capacity will decrease for
technical reasons.
◆
Never use non-Siemens chargers as
W
these could damage the batteries.
◆
Only place the handset in the base/
charging cradle that is intended for it.
The charge status of the batteries appears at the
top right of the display:
‰
batteries flat
Š
batteries 1/3 charged
‹
batteries 2/3 charged
Œ
batteries fully charged
The handset is already registered with the base sta-
tion. You must set the date and time to ensure that
the times of calls are logged correctly (page 7).
Your telephone is now ready to use.
3
Activating/deactivating the handset
Press and hold the end call key
If you place a deactivated handset in the base sta-
tion/charging cradle, it will automatically activate.
Activating/deactivating the keypad lock
You can "lock" the keys on the handset to protect
the keypad against inadvertent activation.
To activate: press and hold the hash key
The display shows the icon
To deactivate: press and hold the hash key
The keypad lock deactivates automatically when
you receive a call and activates again after the call.
When the keypad lock is active you cannot even
call emergency numbers!
Making calls
Making external calls/Ending a call
External calls are calls using the public telephone
network.
~
(Enter the number)
The number is dialed. (Or you can first press and
c
hold
[dial tone] and then enter the number.)
During the call you can adjust the earpiece volume
as follows:
¢
j
H/SET VOL
Select the volume with
with
.
OK
Ending the call/canceling dialing:
Press the end call key
Answering a call
Your handset rings and you wish to take the call:
c
Press the talk key
If "Auto Answer" is active (page 8) just lift the
handset out of its base/charging cradle.
Calling Line Identification
When you receive a call, the caller's number will be
displayed on your handset; the caller's name will
be displayed if it is stored in the directory or if CNIP
has been requested.
Requirements:
1 You have asked your network provider for the
caller's number (CLIP) or name (CNIP) to be dis-
played on your handset screen.
2 The caller has asked the network provider for
his number to be identified (CLI).
a
.
Ø
.
¢
c
.
¢
OK
x
w
and
and confirm
a
.
.
R
.
R
.
Advertisement
Table of Contents
