Setting Up The Handset For Use; Registering The Handset On The Base - Gigaset A345 Manual

Setting up the handset for use

Inserting the batteries
N
To open the battery compartment, press the clip on the compartment
cover inwards and lift up the cover.
N
Insert the batteries ensuring correct polarity (see figure on left).
N
To close, replace the battery compartment cover as shown and press it
closed until it locks into place.
N
Only fit the recommended rechargeable batteries of the
same type recommended by Siemens on page 19. Never
use ordinary (non-rechargeable) batteries as they may pose a
health hazard or cause injury.
N
Do not use a non-Siemens charging unit as this could damage
the batteries.

Registering the handset on the base

You must register the handset on the base in order to make calls.
The display shows *--*--*. Now place the handset on the base with the dis-
play facing forwards;
minute the handset is registered on the base. The idle display is shown (bat-
tery symbol and the internal number of the handset in the top left, plus the
date and time, if they have been set).
If "automatic registration" has not been successful after approx. 1 minute,
either remove the handset from the base for approx 5 seconds and then insert
it again, or register it manually (see page 9).
REGISTER HS
flashes in the display. After around one
4