Setting Date/Time; Setting Up The Handset For Use - Gigaset A150 Manual

Setting up the handset for use

The display is protected by a plastic film. Please remove the protective film!
Inserting the batteries and closing the battery cover
Warning
Use only the rechargeable batteries recommended by Gigaset Communications GmbH (
ventional (non-rechargeable) batteries as this could result in significant health risks and personal injury. For example,
the batteries could explode. The phone could also malfunction or be damaged as a result of using batteries that are
not of the recommended type.
¤
Insert the batteries with the polarity in the cor-
rect direction.
The polarity is indicated in the battery compartment.
Initial charging and discharging of the batteries
The correct charge status can only be displayed if the batteries are first fully charged and discharged.
¤
Charge the handset in the base for 6.5 hours.
6.5
The handset must only be placed in the designated Gigaset base or charging cradle.
h
¤
After charging the handset for the first time, remove the handset from the base and only replace it
when the batteries are fully discharged.
Please note
◆
The handset is pre-registered with the base. If you have purchased a model with multiple handsets, all handsets
will already be registered with the base. You do not need to register the handset again. The internal handset
number appears in the top left of the display, e.g. 1 (
However, if a handset is not registered with the base (Register HS or Put into base is displayed), please register
the handset manually (
◆
If you have purchased multiple devices, you can upgrade your Gigaset to a cordless PABX by registering all
A150/A250 handsets at the same base (
◆
After the first battery charge and discharge, you may place your handset in the charger after every call.
◆
Always repeat the charging and discharging procedure if you remove the batteries from the handset and rein-
sert them.
◆
The batteries may warm up during charging. This is not dangerous.
◆
After a while, the charge capacity of the batteries will decrease for technical reasons.
Setting the date and time
Set the date and time so that the correct date and time can be assigned to incoming calls, and so that the alarm can be
used.
¤ u
¤
MENU Settings
~
¤ ¤
Time (enter hours and minutes in 4-digit format)
¤ a
(press and hold to return to idle status)
When entering the time and date, you can move the position of an entry to the left or right by pressing the control key
u
up or down.
Please note
¢
S. 10).
¢
¤ ¤ ¤
OK Date/Time OK
5
¤
First insert the battery cover at the top a.
¤
Then press the cover
¤
To reopen the battery cover, grip into the cavity on the
casing, then pull the battery cover in an upward direction.
¢
S. 1).
S. 10).
~
¤
Date (enter the day, month and year in 6-digit format)
¤
OK (display message: Saved)
¢
S. 13), i.e. never use con-
until it clicks into place.
b
a
b
¤
OK