Table of Contents
Advertisement
Care
Wipe the base station and handset with a damp
cloth or an antistatic wipe. Never use a dry cloth!
This can cause static!
Contact with liquid
If the handset has come into contact with liquid:
1 Switch the handset off and remove the bat-
tery pack immediately.
2 Allow the liquid to drain from the handset.
3 Pat all parts dry, then place the handset with
the battery compartment open and the keypad
facing down in a dry, warm place for at least
72 hours (not in a microwave, oven etc.).
4 Do not activate the handset again until it is
dry.
When it has fully dried out you will normally be
able to use it again.
Questions and answers
If you have any queries about the use of your tele-
phone, go to
www.siemens.com/gigasetcustomercare
for assistance 24/7. The table below contains a list
of common problems and possible solutions.
Problem
Cause
Nothing
The handset is not
appears in the
switched on.
display.
Battery pack is
flat.
No response
The keypad lock is
to key press,
activated.
"HOLD KEY"
appears in the
display.
No wireless
The handset is
connection to
outside the range
the base, dif-
of the base.
ferent icons
The handset is not
flash in the
registered.
display.
The base is not
switched on.
Cords not routed
correctly
!
Solution
Press the end call
a
key
for approx.
5 seconds or place
the handset in the
base.
Charge/replace the
battery pack (page 2).
R
Press the hash key
for approx. 2 sec
(page 3).
Move the handset
closer to the base.
Register the handset
(page 4).
Check the power con-
nector at the base
(page 2).
Check cord routing
(page 2).
7
Authorisation
This device is intended for connection to analogue
networks outside the EEA (with the exception of
Switzerland) depending on national type approval.
Country-specific requirements have been taken
into consideration.
We, Siemens Home and Office Communication
Devices GmbH & Co. KG, declare that this device
meets the essential requirements and other rele-
vant regulations laid down in Directive 1999/5/EC.
A copy of the 1999/5/EC Declaration of Conformity
is available at this Internet address:
http://www.siemens.com/gigasetdocs.
Hide quick links:
Advertisement
Table of Contents
